forums.ps2dev.org

[jeffpsp1]

I only have one memory stick and I have no money to buy a new one. I do have a memory stick pro duo writer though so i tried the .bat file thing out but couldn't figure it out. I need some help big time. I was wondering if there is another way or if someone can simplify the .bat file way.





here is the way i was talking about
http://www.psphacker.com/2005/06/single-memory-stick-method-for.html#comments
_________________
-/-/-/-//-/-/-/-//-/-/-/
the system is down-/
the system is down-/
the system is down/-
the system is down-/
-/-/-/-/-/-/-/--/-/-/-/

[jeffpsp1]

Single Memory Stick Method for Homebrew on 1.5

We have found a single memory stick method for using the Swaploit method to run Homebrew on 1.5 PSPs on this Japanese site. While not exactly practical, this method is certainly interesting. The translation might be a bit rough, but you should be able to figure it out:

**Notice**
* Since the memory stick writing is delayed, you must wait several seconds
* Batch file will be made
* Waiting 10 seconds is alright, pay attention to the delay, don’t pull it out too quickly or too slowly

*Preparation
1. Create a .BAT file “Autorun.bat” in a text editor and insert the following
From here *******************************************
Ren C: \psp\game\psp-dev\eboot.pbp eboot.pbp3
Ren C: \psp\game\psp-dev\eboot.pbp2 eboot.pbp
To here *********************************************
The drive letter is the letter of your memory stick writer. Change as needed.
2. Copy EBOOT.PBP in to MS1 PSP/GAME/PSP-DEV on the memory stick
3. Rename EBOOT.PBP file inside MS2 directory to EBOOT.PBP2 and copy it to the same location on the memory stick.
4. Copy over all other needed files (for whatever homebrew you are trying to run)
5. Open command prompt (start > run > cmd > enter)
6. Go to the directory of the BAT file you created (example type: CD C:\PSP15\)

7. Type “autorun.bat” but you do not yet press ENTER

Preparation is complete

*Use
1. Memory Stick is inserted in the PSP
2. The Loader is Started
3. The instant it starts, remove the memory stick, and put it in your PC Memory Stick writer
4. Push ENTER and it executes the renaming BAT
5. Wait a few seconds for writing to complete
6. When you think it is complete, remove the memory stick and insert it to your PSP
7. If you did it right your homebrew will start
_________________
-/-/-/-//-/-/-/-//-/-/-/
the system is down-/
the system is down-/
the system is down/-
the system is down-/
-/-/-/-/-/-/-/--/-/-/-/

[TheBrooster]

Or wait until tomorrow, the wor has it that PSP-DEV are releasing a direct boot homebrew method for firmware v1.5 ( see exploit forum )